🕘 8:00 AM – 5:00 PM, Monday – Saturday (GMT+8) 📞 +86 17561670738
Technical guide

Cargo Lashing Strap Standards Explained

Lashing straps are not one global product. Europe, Australia, New Zealand, North America and Brazil each apply a different standard - and a strap certified for one market may not be accepted in another. Here is what each standard actually requires.

The three you will meet most often

StandardMarketApplies to
EN 12195-2European Union / UKWeb lashing made from man-made fibers
AS/NZS 4380Australia & New ZealandLoad restraint - lashing capacity (LC) in daN
ASME B30.9United StatesSlings - alloy steel chain, wire rope, synthetic web

Other relevant documents are GB/T 23914.2 in China, DIN EN 12195-1 for the calculation of lashing forces, and the US FMCSA / CVSA cargo securement rules for road freight.

LC, WLL and breaking strength are not the same thing

This is the single most misunderstood point in cargo control:

  • LC (lashing capacity) - the maximum force a strap is allowed to sustain in service, expressed in daN (1 daN = 10 N) under EN 12195-2 and AS/NZS 4380, or in kg under some regional schemes
  • WLL (working load limit) - the same concept expressed as a mass, used in US practice
  • Minimum breaking strength - the load at which the assembly fails; standards require it to be at least twice the LC or WLL

A strap stamped LC 2500 daN is therefore rated for about 2.5 t of restraint force, with a breaking strength of at least 5 000 daN.

What else the standards control

Labeling. Every strap must carry a permanently marked label showing the standard it complies with, the manufacturer, the LC rating, the length and the date of manufacture, plus a warning to use only certified parts. Missing or illegible labels mean the strap should be withdrawn.

STF - standard tension force. The tension a ratchet or cam buckle can pre-load into the strap, typically 350 daN for a 25 mm ratchet, 500 daN for a 35 mm ratchet and 750–1 000 daN for a 50 mm ratchet. High STF is what actually keeps a load from shifting.

Wear and reinforcement. Standards define minimum widths, edge protection requirements and the elongation limits of the webbing.

Use of edge protectors. Where a strap crosses a sharp corner, the standard requires protection - sleeves, corner guards or protective pads.

How to choose for your market

  1. Ask your buyer which standard is enforced at destination - not which one they have always bought
  2. Check whether the destination requires LC in daN or WLL in kg markings
  3. Confirm the number and strength of lashings from the lashing calculation for the vehicle and load
  4. Only use certified components - a strap is only as strong as its weakest fitting

We manufacture and label lashing straps to EN 12195-2, AS/NZS 4380 and ASME B30.9 depending on destination, with the compliance mark printed on the label for each market.