What Is a Synthetic Sling?
A synthetic sling is a flexible lifting device made from high-strength synthetic fiber instead of steel. This guide explains the two main types, how load ratings work, and how to select the right sling for the job.
Definition
A synthetic sling is a lifting device made from high-strength synthetic fiber - most often polyester (PES), polyamide (PA, nylon) or polypropylene (PP). Compared with wire rope or chain, synthetic slings are lighter, softer and far less likely to mark or deform the load, which is why they dominate lifting work in manufacturing, ports, wind energy and aerospace.
There are two primary forms:
| Type | Construction | Best for |
|---|---|---|
| Flat webbing sling | Several layers of high-tenacity polyester webbing, stitched into a flat, wide band with reinforced eyes | Regular, flat loads - steel plates, precast panels, pipes, timber |
| Round sling (endless) | Continuous loop of high-tenacity yarn inside a woven protective sleeve | Irregular and delicate loads - machined parts, painted surfaces, wind components |
Both types are covered by EN 1492-1 (webbing slings) and EN 1492-2 (round slings) in Europe, and by ASME B30.9 in the United States.
Why the color matters
Round slings are color-coded by working load limit (WLL) so a rigger can identify capacity instantly, from ground level, without reading a label:
| Color | WLL |
|---|---|
| Purple | 1 t |
| Green | 2 t |
| Yellow | 3 t |
| Grey | 4 t |
| Red | 5 t |
| Brown | 6 t |
| Blue | 8 t |
| Orange | 10 t |
Safety factor: what the numbers mean
Synthetic slings are rated with a safety factor - the ratio of breaking strength to working load limit. Common values are 5:1, 6:1, 7:1 and 8:1. A 2 t round sling at 7:1 therefore has a minimum breaking strength of 14 t. European webbing and round slings are typically supplied at 7:1, while some export markets specify 5:1 or 6:1; the label on the sling always states which one applies.
Advantages over wire rope and chain
- Non-damaging - no scratching or compression of coated, painted or precision surfaces
- Lightweight - a fraction of the weight of steel at equal capacity, so faster and safer to handle
- Shock absorbing - fiber stretches slightly under load, cushioning dynamic forces
- Corrosion resistant - unaffected by water, oil and most chemicals
- Customisable - lengths, widths, layers, color and end fittings all specified to order
How to select the right sling
- Load weight and shape - choose flat or round, then the rated capacity and length
- Lifting method - straight, choker or basket lifts reduce capacity; the angle between legs matters
- Working environment - high temperature, acids, alkalis and sharp edges all need specific protection
- Service frequency - frequent use calls for a heavier construction and a documented inspection interval
- Standard and certification - confirm the sling is made and tested to EN 1492-1/-2, ASME B30.9 or AS/NZS 4497.1 and carries a traceable label
Inspection
Inspect before every lift: cut or frayed webbing, damaged stitching, a torn or worn sleeve, chemical damage, or a missing label are all grounds for immediate withdrawal from service. Never exceed the rated capacity, never knot a sling, and always protect it from sharp edges.