How to Choose a Ratchet Tie Down Strap
Picking a ratchet strap is not just about the longest strap or the biggest number on the label. This guide walks through the five things that actually decide whether a strap is safe and legal for your load.
Start with the load, not the strap
Before you look at any product, write down three numbers: the weight of the cargo, how it will be restrained (direct, diagonal or over-the-top), and how many straps you plan to use. The required lashing capacity (LC) per strap comes from those numbers, not the other way round. A strap that is too strong is rarely a problem; a strap that is too weak is.
Lashing capacity (LC) is the number that matters
LC is the force a strap is rated to hold in use, measured in daN (1 daN ≈ 10 kg / 100 N). It is not the same as breaking strength. Under EN 12195-2, a 50 mm ratchet strap commonly carries an LC of 2,000–5,000 daN, with a much higher breaking strength behind it. Always match the LC printed on the label to the calculation for your load, and check that the ratchet, hook and webbing all carry the same LC — the weakest component sets the real rating.
Width follows capacity
| Width | Typical use | Common LC range |
|---|---|---|
| 25 mm | Motorcycles, small cargo, utilities | 400–1,000 daN |
| 35–50 mm | General truck and trailer lashing | 2,000–5,000 daN |
| 75–100 mm | Heavy haul, steel coils, industrial | 6,000–10,000+ daN |
A wider strap spreads force over a larger contact area and is less likely to cut into packaging or edges. For the same LC, a wider strap is usually the safer choice.
Length and end fittings
Measure the real path over the load, including the part that wraps around it, then add enough tail to work the ratchet. Common fixed lengths are 2 m, 3 m, 5 m and 10 m; endless versions are specified by overall loop length. End fittings must suit the anchor point: S-hooks for general use, J-hooks for deep anchor rails, snap hooks where a quick release is needed, and flat hooks or bridle assemblies for heavy haulage.
The compliance checklist
- The label states LC, standard (EN 12195-2 or AS/NZS 4380), and manufacturer — not just a marketing "ton" figure.
- Webbing, ratchet and fittings all meet the same LC.
- The ratchet has a comfortable grip and a positive locking action.
- You have enough straps for the load path, with a documented lashing calculation for commercial transport.
- For Europe and Australia, the strap can be supplied with the declaration and test reports buyers ask for.
A note on price
Two straps of the same size can differ a lot in price. The difference is usually in the yarn (high-tenacity polyester vs. cheaper staple), the stitching pattern, and whether every production batch is pull-tested. Those are the things that decide whether the label number is real.
Frequently asked questions
- What LC do I need for a ratchet tie down strap?
- LC must come from a lashing calculation for your specific load, restraint method and number of straps. Never guess from a marketing 'ton' figure. Common 50 mm straps run from 2,000 to 5,000 daN.
- Does a wider strap hold more?
- Width usually tracks capacity because a wider webbing can carry more yarn, but the rating that matters is the stated LC. For the same LC, a wider strap spreads force better and is gentler on the load.
- Can I use the same strap in Europe and Australia?
- Often yes in principle, because both EN 12195-2 and AS/NZS 4380 rate lashings by LC in daN. Always confirm the exact standard and documentation your market requires.