How to Inspect a Lifting Sling Before Every Lift
Sling failures are rarely sudden and unexplained. In most cases the warning signs were visible — the person doing the lift just did not know what to look for. This checklist fixes that.
Why inspection matters
A sling is a safety-critical item. Webbing can be cut, stitching can loosen, and a sleeve can hide internal yarn damage. A two-minute check before each lift is the cheapest insurance you can buy.
The pre-use check, step by step
- Read the label. Is the WLL legible? Is the standard and manufacturer identifiable? An unreadable label means the sling comes out of service.
- Run your hands along the full length. Feel for cuts, fraying, lumps, stiff or soft spots that indicate internal damage.
- Inspect the stitching and eyes. Look for broken, pulled or loose stitches, and for distortion around the reinforced eyes.
- Check the sleeve (round slings). A torn or worn-through sleeve exposes the load-bearing yarn — withdraw immediately.
- Look for chemical and heat damage. Discolouration, brittleness, melted or glazed areas are all rejection criteria.
- Check fittings — hooks, rings and links for deformation, cracks or excessive wear.
When to withdraw a sling from service
- Cuts, tears or fraying in load-bearing webbing
- Damaged stitching or a deformed eye
- A torn sleeve with exposed yarn (round sling)
- Chemical burns, heat damage or UV embrittlement
- Missing or illegible identification label
- Any sling that has been overloaded or involved in a shock event
Periodic inspection and records
Pre-use checks are the operator's job; periodic inspection (typically every 6–12 months depending on duty and local rules) is a documented task. Keep a simple log: date, sling ID, condition, and the name of the person who checked it. For commercial lifting, this record is often the first thing requested after an incident.
A note on storage
Store slings clean, dry and away from direct sunlight, sharp tools and chemicals. Coil or hang them loosely — never tie knots, and never store them under a load. Good storage does more for sling life than most people expect.
Frequently asked questions
- How often should I inspect a lifting sling?
- Check before every lift, and carry out a documented periodic inspection typically every 6–12 months depending on duty and local rules.
- When should a sling be removed from service?
- Remove it for cuts or fraying in load-bearing webbing, damaged stitching, a torn round-sling sleeve, chemical or heat damage, an illegible label, or any overload event.
- Can I still use a sling with a faded label?
- No. If the WLL and identification cannot be read, the sling must come out of service until it is properly identified.