🕘 8:00 AM – 5:00 PM, Monday – Saturday (GMT+8) 📞 +86 17561670738
Technical guide

LC vs WLL vs Breaking Strength: What the Numbers Mean

Buyers often compare straps by 'tons' and get confused when the same product carries several different numbers. Here is what each rating actually measures.

The four numbers you will see

TermStands forWhat it means
LCLashing CapacityThe force a lashing assembly is rated to hold in service; the key number for tie-down straps in Europe and Australia
WLLWorking Load LimitThe maximum load a lifting item is rated to handle; the standard term in the US and for lifting slings
BL / MBSBreaking Load / Minimum Breaking StrengthThe force at which the product fails in a pull test
SFSafety FactorThe ratio of breaking strength to the working rating (e.g. 7:1)

LC and WLL are not interchangeable

LC describes a restraining force — how hard a strap holds cargo down. WLL describes a lifting force — how much weight a sling may carry. Because the failure modes and dynamics differ, the two are not the same number, and markets use different conventions:

  • Europe / Australia: tie-down straps are labelled with LC in daN under EN 12195-2 and AS/NZS 4380. Australia notably uses LC where the US uses WLL.
  • United States: webbing and round slings are labelled with WLL in pounds or tons under ASME B30.9 and WSTDA standards.

How the safety factor connects them

A 2 t round sling at a 7:1 safety factor has a minimum breaking strength of 14 t. The safety factor accounts for wear, dynamic shock, angle effects and uncertainty in the load. Lifting slings commonly use 5:1, 6:1, 7:1 or 8:1; the label always states which applies. Higher factors are used where loads are dynamic or the consequences of failure are severe.

Why 'ton' alone is misleading

A strap advertised as '5 ton' might mean a 5,000 daN LC, a 5 t breaking strength, or a marketing figure with no standard behind it. Those can differ by several times. For a real purchase decision, ask for the rated LC or WLL, the standard, and the test report — never rely on a single rounded number.

A note on repeated lifts

Lashing and lifting ratings assume the product is undamaged and used correctly. Angle, choker configurations and edge contact all reduce the effective capacity. When in doubt, derate rather than assume.

Frequently asked questions

Is LC the same as WLL?
No. LC (lashing capacity) is a restraining force used for tie-down straps; WLL (working load limit) is a lifting rating. They are not interchangeable and different markets use different terms.
What does a 7:1 safety factor mean?
It means the minimum breaking strength is seven times the working rating. A 2 t sling at 7:1 has a breaking strength of at least 14 t.
Why does Australia use LC instead of WLL?
Australian and New Zealand load-restraint practice rates tie-down assemblies by LC under AS/NZS 4380, while the US and lifting-sling standards typically use WLL.
Keep reading

More technical guides

What Is a Synthetic Sling?

Synthetic slings are flexible lifting slings made from polyester, nylon or polypropylene. Compare flat webbing and round.

Read the guide →

Rigging Hardware: Types, Applications and Safe Use

A practical guide to rigging hardware - shackles, hooks, master links, wire rope clips, turnbuckles, eye bolts and.

Read the guide →

Cargo Lashing Strap Standards Explained

Which standard applies to your lashing straps - EN 12195-2 in Europe, AS/NZS 4380 in Australia and New Zealand, ASME.

Read the guide →

Recycled Polyester Yarn for Webbing and Lifting Slings

Recycled (rPET) polyester yarn for webbing, lashing straps and slings - how it is made, what it saves, what it costs.

Read the guide →

Tarpaulin Straps: What They Are and How to Choose

A tarpaulin strap holds a tarp down - webbing, hook and tensioner. Compare ratchet, cam buckle and winch styles, widths.

Read the guide →

How to Choose a Ratchet Tie Down Strap

Choose the right ratchet tie down strap by load, lashing capacity (LC), width, length and end fitting. A practical guide.

Read the guide →

EN 12195-2 Explained

What EN 12195-2 requires for ratchet lashing straps: LC marking, elongation limits, testing, labelling and the.

Read the guide →

What Is a Round Sling?

A round sling is a continuous loop of high-tenacity yarn inside a protective sleeve. Learn how colour codes work, when.

Read the guide →

Webbing Sling vs Chain Sling: Which Should You Use?

Compare synthetic webbing slings and chain slings on load protection, weight, temperature, durability and cost, with a.

Read the guide →

How to Inspect a Lifting Sling Before Every Lift

A practical pre-use inspection checklist for webbing and round slings: what to look for, when to withdraw a sling from.

Read the guide →

Studless Anchor Chain vs Stud Link: What's the Difference?

Compare studless and stud link anchor chain: construction, strength, weight, handling and which marine or mooring.

Read the guide →

Tarpaulin Straps: What They Are and How to Choose

Tarp straps secure covers on trucks, trailers and cargo. Learn the types, materials, lengths and how to pick the right.

Read the guide →

Ratchet Strap vs Cam Buckle Strap

Ratchet vs cam buckle straps compared on tension, speed, load protection and typical uses, so you can pick the right.

Read the guide →

Curtainside Lashing Straps Explained

How curtainside (curtain sider) lashing straps work, why over-centre buckles are used, and how to secure cargo inside a.

Read the guide →

Flat Webbing Slings: Types, Ratings and Selection

A guide to flat webbing slings: single/double leg, WLL colour codes, end fittings, EN 1492-1 and how to select the right.

Read the guide →

Winch Straps: Selection and Safe Use

What a winch strap is, how it differs from a ratchet strap, common widths and ratings, and how to use it safely on.

Read the guide →